Shutdown steps of laser cutting machine

Shutdown steps of laser cutting machine

As a device that uses laser to perform cutting processing, laser cutting machine has very strict requirements for all aspects of operation. Once a slight operation error occurs, it may have a bad effect on the equipment. Therefore, it is very important to strictly regulate your own operating methods. Therefore, the following editor will describe in detail the operation steps of shutting down the device.

　　1. Turn the power adjustment function counterclockwise to adjust the knob of the laser cutting machine to low power.

　　2, turn off the electronic shutter switch-high voltage start switch-laser start switch in turn.

　　3. After the turbine stops running, turn on the ManualBackfill button on the laser board.

　　4. The ManualBackfill light is red and the ManualBackfill light is off, and the recharging is over.

　　 5. Turn off the power of the laser cutting machine-machine power-turn off the power switch of the chiller, air compressor and refrigeration dryer in turn.

　　6. Turn off the laser working gas CO2, N2, He, and O2- in turn, turn off the air compressor and refrigeration dryer.

　　7. Clean up the site and CNC machine tools.

The above is about the shutdown steps of the laser cutting machine. Many people basically ignore the power-off of the equipment and think that it is not necessary to be so troublesome. In fact, it is not. Reasonable shutdown operations can keep the equipment in good performance and use time. longer. If you do not follow the correct method, it will cause many unforeseen problems.