Working conditions of laser cutting machine

Working conditions of laser cutting machine

Although the product performance of the laser cutting machine itself is very good, in order to fully and stably play its role, the working environment of the equipment must meet its working conditions to make the equipment work better. The following editor will talk about the working conditions of the laser cutting machine.

　　1, temperature

　　Laser cutting machines generally work in a constant temperature environment. Only under constant temperature conditions can the normal operation of the equipment and the processing accuracy of the equipment be guaranteed. The working temperature of the semiconductor in the cutting machine system is required to be below 40~45℃. When the room temperature reaches 35℃, the internal temperature of the electrical cabinet can reach above 40℃. When the room temperature is too high, the failure rate of the CNC system will increase, so in order to make the system good Work, the working temperature should not exceed 35℃.

　　2, humidity

The relative humidity of the working environment of the cutting machine is generally less than 75%. Because the cutting machine in high temperature and high humidity is powered off, the water molecules in the air will produce condensation on the circuit board of the power supply or driving device. Condensation on the circuit board causes a short circuit, which can cause machine failure.

　　3, voltage

　　 The power supply voltage fluctuates greatly, which will cause the laser cutting machine to alarm for undervoltage or overvoltage, and even data loss. Therefore, the voltage is generally required to be within ±10% of the rated operating value. If the voltage is unstable, it is recommended to equip with a regulated power supply.

　　4, dustproof

In the long-term cutting process, if there is no good dust removal, the conductive dust will affect the health of the operator. In addition, if the electrical cabinet is not closed, the dust enters the electrical cabinet and deposits on the circuit board or module, which will cause damage to the electrical components. Especially high-voltage components. Therefore, good dust removal equipment is required when the equipment is working.

　　5, ground wire

　　The normal operation of the equipment must have a good grounding.

　　 6, light

　　 Avoid direct sunlight on the laser cutting machine, and the room should be equipped with good lighting equipment.

　　7, ventilation

　　 We mentioned humidity and conductive dust in the above working conditions. Ventilation is a natural method of elimination. Effective ventilation can better ensure the good operation of the cutting machine and the health of the operators.

　　 Therefore, when installing the laser cutting machine, it must be installed in a place that meets the above working conditions to better avoid the interference of external factors (such as environmental factors) and make the laser cutting machine work normally.